| Loop
Frequency: Four Frequencies (normally in the range
of 20 to 100 kilohertz) are DIP switch selectable
from the front panel.
Reset:
Changing any DIP position (except SW 1, and SW
2, frequency selection) will reset the detector.
After changing the frequency selection switches,
the detector will require a RESET. Reset will
clear the loop fault memory.
Sensitivity
Boost: An external DIP switch setting may be turned
ON to increase sensitivity ONLY during the DETECT
period. When a vehicle enters the loop, the detector
sensitivity is boosted to a higher level than
the vacant loop setting. All features are listed
in the downloads section
|
